Back to Mirrakoi.com

Not sure how to create surface

I am trying to make surface using patch, but not sure why failed to build it. How can I upload my file?

Hi @flim,

To upload your file, when writing in Discourse clik on “Upload” then add it from your computer.
Please check this to see how Xirus Patch works: https://mirrakoi.com/xiruscad-documentation/xiruscad-surface-from-curves/xiruscad-patch/

Best,
Pablo

I tried to upload but the forum did not allowed me to upload. It prompt: “Sorry, new users can not upload attachments.”

Best regards,
Frederick

Hi @flim,

Indeed, there seems to be an issue with file attachments. Please send the file to support@mirrakoi.com instead.

Just as a note, one common reason why XirusPatch might not work is when the input line curves are too complex: they must be each of just two points (or a degree 5 NURBS curve with a single Bézier span).
Xirus lines satisfy these requirements.

If you have other kind of curves, try converting them to Xirus and rebuilding them with only 2 points. There will be a change of geometry depending on the complexity of the initial curve.

Best,
Pablo